I’m generating the Ampli.swift file using ampli pull for a iOS project and the file gives me a few messages about incorrect Amplitude usage (see screenshot). I can remove all these calls and everything is fine, but this is a manual step that I can’t do every time ampli pull is run.
Best answer by irmalexandra
Apparently this is because I have too old a version of Amplitude but I can’t update because I also have Flutter integrated which doesn’t seem to support Ampli SDK
Apparently this is because I have too old a version of Amplitude but I can’t update because I also have Flutter integrated which doesn’t seem to support Ampli SDK
+8
Thanks for writing in! Unfortunately, it is the case that we do not have a wrapper for the Flutter SDK at this moment for Ampli. If you don’t mind, if you can PM me your Org ID and the email you use for Amplitude, I can submit it as a request so that they are at least aware that there is demand for it.
Kind Regards,
Denis
If you don't have an Amplitude account, you can create an Amplitude Starter account for free and enjoy direct access to the Community via SSO. Create an Amplitude account. You can also create a Guest account below!
If you don't have an Amplitude account, you can create an Amplitude Starter account for free and enjoy direct access to the Community via SSO. Create an Amplitude account. Want to sign up as a guest? Create a Community account.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
